| Indicator name |
The value of the class |
| S240 |
S5001) |
| Profile |
Smooth |
According to figures 1 and 4 |
According to figures 2 and 3 |
| nominal diameter dnom, mm |
6-40 |
6-40 |
4-16 |
| Physical or yield strength Re, MPa, no less2) |
240 |
500 |
500 |
| The ratio of tensile strength to the physical or proof strength Rm/Re, no less2) |
1,3 |
1,08 |
1,053),4) |
| Complete elongation at maximum load Аgt %, no less |
— |
5,0 |
2,54),5) |
| Relative elongation δ5, %, no less |
25 |
14 |
126) |
Bending tests cold:7)
bend angle
the mandrel diameter, mm |
180°
0,5dnom |
180°
3dnom9) |
180°8)
3dnom |
Bending tests with unbending:7)
the angle of bending
straightening angle
mandrel diameter, mm |
— |
90°
20°
5dnom10) |
90°
20°
5dnom |
- For armature S500 class, made by cold deformation, all the mechanical properties should be taken for S500 grade fixtures, made in drawing 2.
-
As the yield strength Re adopted the upper limit of the yield ReH. In unexpressed yield point determine proof stress tolerances on the amount of plastic deformation of 0.2%.
- For armature diameter 4.0, 5.0 and 5.5 mm - Rm/Re not less than 1.03.
- For armature with a diameter of 4.0 mm in the preparation of indicators below the specified tensile strength Rm shall not be less than 650 MPa.
- For armature diameter 4.0, 5.0 and 5.5 mm - Аgt not less than 1.5%.
-
For armature with a diameter 4.0 and 5.0 mm controlled δ100, adopted by not less than 2.5%.
- Suitability for bending should be determined by tests to bending or bending with unbending.
- For armature with a diameter of 5.0 mm and 4.0 perform tests on the bend in accordance with GOST 1579. The minimum number of bends - five.
- For armature with a diameter of more than 16 mm - diameter mandrel — 6 dnom.
- For armature 20 and diameter 25 mm diameter mandrel - 8 ddnom. For armature with a diameter greater than 25 mm diameter mandrel - 10 dnom.
In bundles, weight 5 tons max., with banding by wire rod 6,5 mm in 6 places min. equally distributed over bundle. Each bundle is provided
with 2 steel straps for multiple lifting.
Reinforcing die-rolled section bars S500 class in coils